![]() ![]() This by permanently lighting the alarm LED (upon unsetting the system).ĭetectors can be reset by taking the latch line high and then low again. Any detectors triggered while the system is set will indicate Latch connected to Set Positive (SW+, Set+): The LEDs will be disabled while System, but only a part thereof, Texecom cannot accept responsibility or liability forĪny damages whatsoever based on a claim that the Prestige DT failed toĭue to our policy of continuous improvement Texecom reserves the right toĬhange specification without prior notice. As the Prestige DT is not a complete alarm The Prestige DT is designed to detect the movement of an intruder and activateĪn alarm control panel. The latch terminal (see Section 5) can perform several different functions No false alarms from 80MHz to 2GHz at 10V/m. ![]() Independently Certified to EN 50130-4 : 1996. Suitable for use in a PD 6662/BS EN 50131-1 ![]() I N S TA L L AT I O N I N S T R U C T I O N SĪsk your distributor today for the Texecom full colour Product Guide. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |